Flexible Metal Conduit is a flexible part with excellent
performance in modern industrial pipelines. The structure is a stainless steel
metal hose braided with one or more layers of steel wire or steel belt net
sleeves, and the ends are equipped with joints or flange heads for conveying
various media. Its characteristics: corrosion resistance, high and low
temperature resistance, light weight, small size, good flexibility.
Flexible Metal Conduit EMI Proof
The main purpose:
1. Conveying corrosive chemical media or organic solvents. (Such as: nitrogen water, acetone, etc.) 2. Transport high temperature gas, hot oil and other high temperature media 3. Transport low temperature or ultra low temperature media 4. Transport water, gasoline and other media under high temperature environment. 5. Pipes that need vibration damping or noise reduction. Aluminum Flexible Metal Conduit Supplier introduced the widespread use of metal hoses in various industries. In actual processing and use, there are often some reasons for metal hose damage. This is where we need to pay attention, and then we will take everyone to understand the protection points of metal hoses. The following are the reasons for this:
1. Metal hoses to be transported to the site should be stacked and neatly stacked, and they should not be stepped on.
2. The metal hose should be covered and protected to prevent wind and rain from aging it in advance.
3. The metal hose should be cut straight and not beveled.
4. Method of metal hose connector: A large metal hose with a length of 0.3 meters should be outsourced at the metal hose connector, and both ends must be tightened in half, with no gap left in the middle. In order to ensure that there is no gap in the middle, the ends of the two joints should be marked. When done, wrap it tightly with tape to prevent slurry leakage.
5. The position of metal hoses must be accurately positioned, especially near the joints. The distance between the reinforcing bars of the metal hoses must be 0.5 meters, which is indispensable.
6. When the welding rebar is close to the metal hose, take measures to protect the metal hose from being burned. If you accidentally get burned, the burn should be wrapped tightly with tape.
7. Considering that the number of metal hoses on the top plate is gradually decreasing, all parts that conflict with metal hoses should avoid metal hoses.
8. When pouring concrete, do not put material into the metal hose. Vibrators must not collide with metal hoses. It is strictly forbidden for two vibrators to vibrate with a metal hose in between. Especially when the web is vibrated, it is strictly forbidden to vibrate the vibrator at the same position for a long time. The vibrating time shall not exceed 20 seconds.
9. When removing the mold, pay attention to protect the leaking metal hose at the end.
The above points need everyone's attention. These problems can be avoided by paying attention and careful attention during construction, and paying attention to these details. If the above problems occur, resulting in damage to the metal hose, it should be replaced immediately without construction to avoid loss. Our company also has Flexible Metal Conduit EMI Proof on sale, welcome to consult.